Made in IBM Labs: Collaboration Aims to Harne the Energy of ,000 Suns

ZURICH - 22 Apr 2013: Today on Earth Day, scientists have announced a collaboration to develop an affordable photovoltaic system capable of concentrating, on average, the power of 2,000 suns, with an efficiency that can collect 80 percent of the incoming radiation and convert it to useful energy. The proposed system can be built anywhere sustainable energy, drinkable water and cool air are in short supply at a cost of three times lower than comparable systems.

A three-year, $2.4 million (2.25 million CHF) grant from the Swiss Commission for Technology and Innovation has been awarded to scientists at IBM Research; Airlight Energy, a supplier of solar power technology; ETH Zurich (Professorship of Renewable Energy Carriers) and Interstate University of Applied Sciences Buchs NTB (Institute for Micro- and Nanotechnology MNT) to research and develop an economical High Concentration Photovoltaic Thermal (HCPVT) system.

Based on a study by the European Solar Thermal Electricity Association and Greenpeace International it would take only two percent of the Sahara Desert's land area to supply the world's electricity needs*. Unfortunately, current solar technologies on the market today are too expensive and slow to produce, require rare Earth minerals and lack the efficiency to make such massive installations practical.

The prototype HCPVT system uses a large parabolic dish, made from a multitude of mirror facets, which is attached to a tracking system that determines the best angle based on the position of the sun. Once aligned, the sun's rays reflect off the mirror onto several microchannel-liquid cooled receivers with triple junction photovoltaic chips -- each 1x1 centimeter chip can convert 200-250 watts, on average, over a typical eight hour day in a sunny region.

The entire receiver combines hundreds of chips and provides 25 kilowatts of electrical power. The photovoltaic chips are mounted on microstructured layers that pipe liquid coolants within a few tens of micrometers off the chip to absorb the heat and draw it away 10 times more effective than with passive air cooling.

The coolant maintains the chips almost at the same temperature for a solar concentration of 2,000 times and can keep them at safe temperatures up to a solar concentration of 5,000 times. The pumping power for the cooling is inspired by the hierarchical branched blood supply system of the human body.

We plan to use triple-junction photovoltaic cells on a microchannel cooled module which can directly convert more than 30 percent of collected solar radiation into electrical energy and allow for the efficient recovery of waste heat above 50 percent, said Bruno Michel, manager, advanced thermal packaging at IBM Research. We believe that we can achieve this with a very practical design that is made of innovative concrete trackers, primary optics composed of inexpensive pneumatic mirrors and structures made of concrete -- it's frugal innovation, but builds on decades of experience in lightweight and high strength concrete elements used for building bridges.

The multi-chip receiver design is based on high power processor coolers developed in a previous collaboration between IBM and the Egypt Nanotechnology Research Center.

The design of the system is elegantly simple. said Andrea Pedretti, CTO of Airlight Energy. We replace expensive steel and glass with low cost concrete and simple pressurized metalized foils. The small high-tech components, in particular the microchannel coolers and the molds, can be manufactured in Switzerland with the remaining construction and assembly done in the region of the installation. This leads to a win-win situation where the system is cost competitive and jobs are created in both regions.

The solar concentrating optics will be developed by ETH Zurich. Advanced ray- tracing numerical techniques will be applied to optimize the design of the optical configuration and reach uniform solar fluxes exceeding 2,000 suns at the surface of the photovoltaic cell, said Aldo Steinfeld, Professor at ETH Zurich.

With such a high concentration and a radically low cost design scientists believe they can achieve a cost per aperture area below $250 per square meter, which is three times lower than comparable systems. The levelized cost of energy will be less than 10 cents per kilowatt hour (KWh). For comparison feed in tariffs for electrical energy in Germany are currently still larger than 25 cents per KWh and production cost at coal power stations are around 5-10 cents per KWh.

Water Desalination and Cool Air

Current concentration photovoltaic systems only collect electrical energy and then dissipate the thermal energy to the atmosphere. With the HCPVT packaging approach scientists can both eliminate the overheating problems of solar chips while also repurposing the energy for thermal water desalination and cool air.

To provide fresh water IBM scientists and engineers are utilizing a world leading technology they developed for water-cooled supercomputers. With both the Aquasar and SuperMUC supercomputers water is used to absorb heat from the processor chips, which is then used to provide space heating for the facilities.

Microtechnology as known from computer chip manufacturing is key to enable such an efficient thermal transfer from the photovoltaic chip over to the cooling liquid explains Andr Bernard, head of the MNT institute at NTB Buchs. And by using innovative ways to fabricate these heat transfer devices we aim at a cost-efficient production.

In the HCPVT system, instead of heating a building, the 90 degree Celsius water will pass through a porous membrane distillation system where it is then vaporized and desalinated. Such a system could provide 30-40 liters of drinkable water per square meter of receiver area per day, while still generating electric

LINK:	http://www-03.ibm.com/press/uk/en/pressrelease/40908.wss...
	See more stories from ibm

Most recent headlines