
The Splitter is one of Studio One Professional's coolest features, because it can split by frequency and do multiband processing. I'm a huge fan of the focused, smooth distortion sound you get by splitting guitars into low, mid, and high-frequency bands, and then distorting each one with its own amp sim. But multiband processing is also cool with delay, chorusing, reverb you name it.
That's the good news. The bad news: the Artist version doesn't include the Splitter. However, there is a way to split your audio into three frequency bands. Let's listen to the sound of single-band distortion, which uses the Ampire default setting (MCM 800).
Artist 1 Band.mp3 Compare this to the multiband setting. The amp sounds are also the Ampire default, with a few minor tone knob edits.
Artist Split 3 Band.mp3 If you like the second sound better, keep reading.
Console Setup
Create three pre-fader sends for the track you want to process, and assign them to three FX Channels or Buses (fig. 1). With pre-fader sends, you can turn down the main channel's fader to hear only the processed sound, or turn it up to mix in dry sound for additional parallel processing. Fig. 1 shows the setup used for the 3-band audio example. At the end of this post, there's a download link for a song file that contains this setup.
Figure 1: Console setup for splitting a track into three frequency bands. The colors follow the light spectrum-red is lowest, blue is highest.
Pro EQ2 Settings
Figure 2: Pro EQ2 settings for the low band. The LC filter is optional, to remove ultra-low frequencies. The Pro EQ2 settings start with the default. Only the LC, HC, and Gain parameters need changing. The table shows suggested frequency bands for guitar, but feel free to alter them. The main consideration is that the Low band's HC frequency should equal the Mid band's LC frequency, and the Mid band's HC frequency should equal the High band's LC frequency. All the slopes are 24 dB/octave.
The slight gain control differences compensate for the phase issues inherent in splitting with non-linear-phase filters. Fig. 3 shows white noise going through the splits, and summed at the output-the frequency response is almost perfectly flat. The slight bass rolloff is due to my preference mentioned above for rolling off the Low Band's LC filter (20 Hz, with a 48 dB/octave slope). Similarly, the High band's HC filter rolls off at 20 kHz, with a 48 dB/octave slope. Amp sims don't need those high frequencies anyway.
Figure 3: Summing the splits produces an almost perfectly flat response. Time for Tweakage!
Multiband setups are highly customizable. Pan the bands differently to create a stereo image, alter the band levels, tweak the amp settings to optimize them for a specific band, and so on. The only caution is that because of the heavy filtering, there's less audio going to the amp inputs. So, you may need to turn up the amp gain (or Pro EQ2 gain for one or more bands) to get the sound you want. And of course, this isn't just about amp sims, because multiband chorusing, delay, reverb, and effects combinations are also very cool.
Download the .song file, and you'll have all the EQs and splitting set up so plug in an instrument or load a track, and start playing around.
Download the multiband template in Fig. 1 here.
3-Band-Guitar.song_-1Download
More from PreSonus
16/08/2024
By Craig Anderton
Keyswitch keys enhance expressiveness by letting you trigger various real-time articulations for instruments like strings, brass, guitars, an...
09/08/2024
By Craig Anderton
The Channel Editor places all of a mixer Channel's elements-level fader, inserts, sends, individual effects, input controls, routing, mac...
02/08/2024
By Craig Anderton
Yes, just click here to download 25 Analog Cab IRs.zip. The IRs are 1024 samples long, 48 kHz, 24-bit, and mono, so they work with pretty muc...
26/07/2024
By Craig Anderton
It's been a while since we've had a post for sound design fans. So, let's create some crazy FX for sci-fi/suspense/horror movies,...
24/07/2024
The Black Dahlia Murder guitarist and New Jersey native talks about taking his leap.
A life in music requires passion, creativity, dedication - and for many cr...
19/07/2024
By Craig Anderton
There's no right or wrong way to mix. For example, many successful engineers adjust individual tracks, and then mix groups of tracks....
12/07/2024
By Craig Anderton
I admit it: the following tips are based on personally embarrassing experiences. I like to work fast to keep the creative juices flowing, but...
05/07/2024
By Craig Anderton
You've probably seen ads for packs of MIDI chords that claim to help you write hits that will make your listeners' jaws drop in amaze...
28/06/2024
By Craig Anderton
Some of my favorite guitar sounds involve using Ampire's amp, bypassing its cab, and adding a cab from the Helix Native plugin. Others in...
26/06/2024
The self-taught multi-instrumentalist and St. Louis native talks about taking his leap.
A life in music requires passion, creativity, and dedication - and for ...
21/06/2024
By Craig Anderton
Sure, you can follow your virtual instrument with an audio compressor. But there's a problem: an instrument's dynamics and expressive...
20/06/2024
Watch the independent artist and Wiz Khalifa producer cook up a song in a single day
Imagine meeting someone for the first time and making a song together. Tha...
14/06/2024
By Craig Anderton
Announcement: The 2nd Edition of The Huge Book of Studio One Tips and Tricks is now available as a free download for owners of previous versi...
07/06/2024
By Craig Anderton
Usually, the Vocoder inserts into a track that provides the modulation, and the Vocoder's sidechain receives the carrier. But why be norm...
06/06/2024
The GRAMMY-winning fiddler, songwriter, and New Orleans native talks about taking his leap.
A life in music requires passion, creativity, dedication - and for ...
31/05/2024
By Craig Anderton
Let's get right to what this sounds like. It's not quite feedback or tape reverse, it's well, listen to what it does in this blue...
24/05/2024
By Craig Anderton
A Pro EQ3 stage's gain can respond dynamically to incoming signal level, so that louder inputs kick the gain higher (or lower). But Studi...
22/05/2024
If you're a PreSonus user, you're probably pretty hands-on in producing ...
17/05/2024
By Craig Anderton
When I heard about binaural beats, I was interested-I like beats, and I'm into binaural audio. But this has nothing to do with either o...
15/05/2024
Professional drummer, producer, and New Orleans native talks about taking the leap.
A life in music requires passion, creativity, and dedication - and for many...
08/05/2024
Take the Leap with the Next Generation of PreSonus Audio Interfaces
MEET THE ALL-NEW FAMILY OF QUANTUM AUDIO INTERFACES
The culmination of nearly 30 years of ...
08/05/2024
Take the Leap with the Next Generation of PreSonus Audio Interfaces
MEET THE ALL-NEW FAMILY OF QUANTUM AUDIO INTERFACES
The culmination of nearly 30 years of ...
03/05/2024
by Craig Anderton
About four years ago, I did a tip on multiband gating. Although it was a cool effect, it was guitar-centric, cumbersome to edit, and time-con...
26/04/2024
By Craig Anderton
With this technique, when you play a standard 6-string electric guitar, you'll hear the rich, vibrant sound of a 12-string guitar. The pr...
19/04/2024
By Craig Anderton
Impact XT can launch clips, which is great for songwriting (see the blog post Songwriting with Impact XT). But few people realize that Impact...
12/04/2024
By Craig Anderton
Good mixes often depend on carving out a unique sonic space for each instrument, so you can hear them clearly. Sometimes carving out that spa...
05/04/2024
By Craig Anderton
MIDI guitars are a niche product, because the learning curve can be daunting for some guitar players. However, I'm surprised how many pro...
29/03/2024
By Craig Anderton
As the universe of Studio One users grows, so do opportunities for collaboration. But your collaborator may not be using the same version of ...
22/03/2024
By Craig Anderton
Over three years ago, I wrote a blog post on how to make a drumcoder. Its design was somewhat like a vocoder-drum audio served as a modulat...
15/03/2024
By Craig Anderton
One of Atmos's coolest features is scalability. No matter how complex your Atmos project may be, you can render it as Binaural, 5.1, 5.1....
13/03/2024
Watch the Brooklyn Synthpop duo remix their song Blame in Studio One
Less than 24 hours after meeting each other, producer Luke Moellman and vocalist Jon San...
10/03/2024
By Craig Anderton
The impetus behind this design was wanting to add envelope flanging to amp sims like Ampire. But there's a problem: most amp sim outputs ...
01/03/2024
By Craig Anderton
Supplementing close-miking techniques with room mics gives acoustic sounds a life-like sense of space. Typically, this technique involves pla...
27/02/2024
Notion Mobile v3 took mobile music creation to the next level with support for iOS, Android, Windows, Fire OS and macOS. Now v3.3 adds many enhancements and fix...
26/02/2024
Logic's Grammy-nominated producer breaks down his Sweet Spot.
Before he found success as an avant-garde hip hop producer, 6ix was just 30 units shy of a de...
25/02/2024
The Grammy-nominated multi-Platinum producer breaks down his Sweet Spot.
From the studio with chart-topping artists like Aerosmith and The Fray, to empowering ...
23/02/2024
By Craig Anderton
Do you think of mixes in absolute terms, or relative terms? Knowing the difference, and when to apply which approach, can make a huge differe...
16/02/2024
By Craig Anderton
Calling all beats/hip-hop/EDM/hard rock fans: This novel effects starts with drums modulating the Vocoder's white noise carrier, and take...
09/02/2024
This tip is about working with stereo, NOT about Dolby Atmos or surround-but we're going to steal some of what Atmos does to reinvent stereo panning. Stud...
07/02/2024
The GRAMMY-winning recording and mix engineer shows us how he uses Studio One to create an artful immersive mix.
Jeff Ellis is a force to be reckoned with. The...
02/02/2024
Presence's sound library includes a fine acoustic 12-string guitar, but not an electric one. So, perhaps it's not surprising that one of the more popula...
26/01/2024
At first, this might not seem too exciting. But follow the directions below, and try comping using this method-I don't think you'll be disappointed. Thi...
19/01/2024
You know the feeling: You're tracking or doing an overdub with a virtual instrument or amp sim, but you're frustrated by the excessive latency inherent ...
12/01/2024
Recording audio using more than one feed from the same source may create phase issues. For example, when miking a bass amp and taking a DI (dry) input, the DI...
05/01/2024
If you haven't experimented yet with mid-side stereo miking, you'll be in for a treat when you do. Here's why:
Record background singers with gorge...
29/12/2023
This complements the tip Better Ducking for Voiceovers and Podcasts and the tip Why I Don't Use Compression Anymore. It applies the concept of voiceover duc...
22/12/2023
Engineers sometimes advocate using high-pass filters to clean up the low end and tighten the sound. Others believe that because of issues inherent in highpass...
20/12/2023
The GRAMMY-nominated artist, producer, and songwriter shows us how he uses Studio One to cook a musical idea from scratch.
Josh Cumbee is a triple threat: The ...
15/12/2023
This wasn't a conscious decision, or something I planned. But when I looked through my last few songs while seeking candidates for a book's screenshots,...
08/12/2023
First, a follow-up: In the October 13 tip about creating Track Presets for parallel processing, I mentioned that Track Presets can't include buses, which is...