Friday Tip: Back to the 60s with Preverb

Reverse audio was a common technique back in the days when doing it was a challenge (flipping tape reels over, recording, flipping them back). Now that reverse audio is easy to do, it's uncommon go figure. But let's revive reverse audio with preverb-reverb that swells up to a sound, instead of decaying after it. We'll first look at a method that requires having some silence before the clip to which you want to add preverb, then cover what to do if the clip starts at the beginning of a song. Note: the screen shot shows each step, but you'll end up with only the two yellow clips to create preverb-the other clips are for illustration only (i.e., you don't need to keep copying the clip).

Step 1. Start by copying the clip or track to which you want to add preverb. Use the Paint tool to draw a silent section in front of the copied clip that's equal to or longer than the anticipated reverb decay tail you'll add in the next step, then bounce the silent part and the copied clip together. Tip: Consider rolling off some of the low end on the copy so the kick is less prominent. Kicks don't get along with reverb all that well, and preverb is no exception.

Step 2. Select the bounced clip and type Ctrl+R, or right-click and choose Audio > Reverse Audio. Insert your reverb of choice (the Open Air 480 Hall preset from Halls > Medium Halls is a good place to start) into the copied/reversed track or clip, then set the reverb's Mix control to 100% for an all-wet mix.

Step 3. After your reverb sound is as desired, right-click on this clip and choose Mixdown Selection. This clip contains only the reverb sound.

Step 4. Reverse this clip, and now you'll preverb when you play it along with the original clip. You can also try nudging the preverb left or right to play with the timing-for example if the reverb has pre-delay, the kick and reverberated kick might argue with each other.

To add preverb before the entire song starts so that the preverb leads up to the first sound, select all tracks and shift them to the right to open up a few measures at the song's beginning. Now you can extend the copy of the track or clip you want preverbed to the project start so it includes silence. Continue by copying the original track, reversing, and following the steps detailed previously to add preverb, then shift the tracks back to the their original position.

To hear preverb in a musical context, go to https://store.cdbaby.com/cd/craiganderton and click on the free preview of song 2, The Gift of Goodbye. The preverb is on the guitar solo toward the middle of the song and then occurs again at the end, during the fadeout.

LINK:	http://blog.presonus.com/index.php/2018/07/20/friday-tip-back-60s-prev...
	See more stories from presonus

Most recent headlines