MIT creates black box which draws power from...

Image: Justin Raymond

Engineers from MIT have developed a device that captures power from changing temperatures. The black box, called a thermal resonator uses temperature fluctuations that naturally occur during a 24-hour period. The box generates energy even in the shade, which means it is unaffected by short-term changes in cloud cover, wind conditions, or other environmental conditions, and can be located anywhere. This means it could power electrical devices even in the most remote locations.

The findings are being reported in the journal Nature Communications, in a paper by graduate student Anton Cottrill, Carbon P. Dubbs Professor of Chemical Engineering Michael Strano, and seven others in MIT's Department of Chemical Engineering.

We basically invented this concept out of whole cloth, Strano says. We've built the first thermal resonator. It's something that can sit on a desk and generate energy out of what seems like nothing. We are surrounded by temperature fluctuations of all different frequencies all of the time. These are an untapped source of energy.

While the power levels generated by the new system so far are modest, the advantage of the thermal resonator is that it does not need direct sunlight; it generates energy from ambient temperature changes, even in the shade. That means it is unaffected by short-term changes in cloud cover, wind conditions, or other environmental conditions, and can be located anywhere that's convenient even underneath a solar panel, in perpetual shadow, where it could even allow the solar panel to be more efficient by drawing away waste heat, the researchers say.

The thermal resonator was shown to outperform an identically sized, commercial pyroelectric material an established method for converting temperature fluctuations to electricity by factor of more than three in terms of power per area, according to Cottrill.

The researchers realised that to produce power from temperature cycles, they needed a material that is optimised for a little-recognised characteristic called thermal effusivity a property that describes how readily the material can draw heat from its surroundings or release it. Thermal effusivity combines the properties of thermal conduction (how rapidly heat can propagate through a material) and thermal capacity (how much heat can be stored in a given volume of material). In most materials, if one of these properties is high, the other tends to be low. Ceramics, for example, have high thermal capacity but low conduction.

To get around this, the team created a carefully tailored combination of materials. The basic structure is a metal foam, made of copper or nickel, which is then coated with a layer of graphene to provide even greater thermal conductivity. Then, the foam is infused with a kind of wax called octadecane, a phase-change material, which changes between solid and liquid within a particular range of temperatures chosen for a given application.

A sample of the material made to test the concept showed that, simply in response to a 10-degree-Celsius temperature difference between night and day, the tiny sample of material produced 350 millivolts of potential and 1.3 milliwatts of power enough to power simple, small environmental sensors or communications systems.

The phase-change material stores the heat, says Cottrill, the study's lead author, and the graphene gives you very fast conduction when it comes time to use that heat to produce an electric current.

Essentially, Strano explains, one side of the device captures heat, which then slowly radiates through to the other side. One side always lags behind the other as the system tries to reach equilibrium. This perpetual difference between the two sides can then be harvested through conventional thermoelectrics. The combination of the three materials metal foam, graphene, and octadecane makes it the highest thermal effusivity material in the literature to date, Strano says.

While the initial testing was done using the 24-hour daily cycle of ambient air temperature, tuning the properties of the material could make it possible to harvest other kinds of temperature cycles, such as the heat from the on-and-off cycling of motors in a refrigerator, or of machinery in industrial plants.

These temperature variations are untapped energy, says Cottrill, and could be a complementary energy source in a hybrid system that, by combining multiple pathways for producing power, could keep working even if individual components failed. The research was partly funded by a grant from Saudi Arabia's King Abdullah University of Science and Technology (KAUST), which hopes to use the system as a way of powering networks of sensors that monitor conditions at oil and gas drilling fields, for example.

This approach is a novel development with a great future, says Kourosh Kalantar-zadeh, a distinguished professor of engineering at RMIT University in Melbourne, Australia, who was not involved in this work. It can potentially play an unexpected role in complementary energy harvesting units.

He adds, To compete with other energy harvesting technologies, always higher voltages and powers are demanded. However, I personally feel that it is quite possible to gain a lot more out of this by investing more into the concept. It is an attractive technology which will be potentially followed by many others in the near future.

LINK:	http://www.inavateonthenet.net/news/article/mit-creates-black-box-whic...
	See more stories from teracue

Most recent headlines